• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wiring Question
#1
I have a 71 mustang fastback the gauge feed harness wire that runs along the valve covers. One wire goes to temp, one wire to oil pressure, and a green and red stripped wire with a yellow cap any ideas where this connects to? I still have the original alternator setup with higher amps the regulator is still
[Image: Gauge_feed_harness.jpg]

mounted on the right fender. Any help would be very helpful.  Also where is the best place to to get my 12 volt feed for my carbs electric choke. Thanks
  Reply
#2
The coil.

Let me check your shorts!
http://midlifeharness.com

[Image: Flamicon2.jpg]


[Image: oldfart.png]
  Reply
#3
(03-12-2018, 05:57 PM)midlife Wrote: The coil.

Your saying the green and red wire connects to the coil? Thanks
  Reply
#4
Yes sir, it does.

Let me check your shorts!
http://midlifeharness.com

[Image: Flamicon2.jpg]


[Image: oldfart.png]
  Reply
#5
(03-12-2018, 07:48 PM)midlife Wrote: Yes sir, it does.

Thanks
  Reply
#6
On a Boss it connects into the Rev limiter
(Then those go to the coil)

mark
PS looks like a reproduction harness shown originals were like that)
If you need to know the way the wires were taped let us know
let us know
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Tach and dash wiring/lights project rjpohl 4 217 01-04-2019, 05:18 PM
Last Post: rjpohl
  Alternator wiring problems rjpohl 7 177 12-28-2018, 02:43 PM
Last Post: Don C
  73 mustang ac wiring question DeereFanatic 1 176 12-21-2018, 08:03 PM
Last Post: midlife
  power antenna wiring rjpohl 1 156 11-21-2018, 07:37 PM
Last Post: Don C
  Throttle Position Solenoid Question guyfromhaltonhills 7 290 11-08-2018, 03:41 PM
Last Post: jowens1126
Wrench Another noob dumb question re electrics Ballaratcastle 10 416 10-30-2018, 07:47 PM
Last Post: Mister 4x4
  Need info on this wiring ... EvilPuppetMaster 0 181 10-08-2018, 04:05 PM
Last Post: EvilPuppetMaster
  Under dash wiring harness routing 73429mach 5 502 09-03-2018, 07:14 PM
Last Post: 73429mach



Users browsing this thread: 1 Guest(s)