• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Vacuum hose woes
#1
Hi All
     I have an old '73 Tang, 351 Cleveland, 2V code H.
It's running.  Just got some 1/8" hose delivered today.
I have a schematic but it is worthless.  There were a lot more vac hoses than this thing shows.

Can anybody suggest a good vacuum diagram?


[Image: SAM_0551.jpg]
  Reply
#2
Ugh !!!
Just when I think I have gotten some of this sorted-out, today the engine started running rough and spitting. also the transmission changes gear very late (high RPM). I had to disconnect and plug the distributor Vac hose for it to run good enough to go get fuel.
  Reply
#3
There are a lot of variations, depending on engine, carburetor, transmission, etc. Look through these to see if you find something close:
https://www.7173mustangs.com/thread-vacu...#pid246021



“If you can't explain it simply, you don't understand it well enough.”
--Albert Einstein
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  heater hose routing c9zx 16 13,459 09-02-2018, 10:59 PM
Last Post: rackerm
  A/C vacuum actuator motors Pegleg 16 817 07-14-2018, 06:32 PM
Last Post: rackerm
  Where does this hose go? **UPDATED WITH PHOTOS kindersmach 7 524 07-01-2018, 06:51 AM
Last Post: Hemikiller
  Vacuum hoses rudyck 4 507 04-20-2018, 12:19 PM
Last Post: Hemikiller
Wrench exhaust shield and the heat riser hose on a Q code John J 16 1,806 03-09-2018, 01:39 PM
Last Post: Stanglover
  What is the restrictor air door vacuum motor Dreadknot 9 1,068 01-30-2018, 09:02 AM
Last Post: goforbroke
  SMOKE Machine Diagnostic Emissions Vacuum EVAP Leak Detector Tester mustang7173 0 401 01-23-2018, 07:51 AM
Last Post: mustang7173
  HVAC replacement vacuum lines. Confused..... scgamecock 8 900 01-05-2018, 08:48 AM
Last Post: Hemikiller



Users browsing this thread: 1 Guest(s)