• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Vacuum hose routing
#1
I swear I've read every (and there are MANY) posts related to vacuum hoses, and I've reviewed each and every diagram.  I still can not find a diagram to match my configuration:  '73 351 4V automatic and a/c.  I tagged every hose going to or from the PVS and TCV valves before sending the engine out, but when I got it back from the machine shop:  a few hoses misplaced and none were still tagged, so I'm having to figure it out.

There are diagrams for a 351-4v w a/c and auto, but they don't match what I have under the hood.  Referencing the Ford Shop Manual diagrams posted by DonC for example, I should find my config in 3-14A (attached).  Thing is... I can not find the normally open solenoid valve marked #5 (for PVS valve outlet #2 and the distributor vacuum advance).  I'm assuming it's the same sort of valve as the normally open solenoid valve marked #4 (which is there on my engine and matches the diagram's location) but where the heck is #5?  Under/behind what?  The other thing is, a solenoid valve will have wires and I have no wiring unaccounted for so I just don't think I have the valve indicated as #5 or at least not in the location indicated for #5.  If there is no #5, is the correct routing a direct hose from PVS port 2 to the vacuum diaphragm?

None of my existing hoses have any of the check valves indicated in the diagram (should I be concerned?)  And another thing... the firewall mounted loop (#12 in the diagram) in my car is actually 4 ports.  Not sure that matters to this discussion.

Onward, onward, onward...

 [Image: 1973-Vacuum-Hose-Diagrams-3-14-A.jpg]
  Reply
Share Thread:  


Possibly Related Threads…
Thread Author Replies Views Last Post
  Vacuum Hose Diagrams Don C 13 5,091 02-04-2019, 03:47 PM
Last Post: ZIPNZ
  Vacuum Advances Don C 3 1,658 02-22-2013, 01:43 AM
Last Post: deepanvi



Users browsing this thread: 1 Guest(s)