• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Stabilizer bar bushing install
#1
I bought some new end links and bushings for the stabilizer bar. The old bushings were a softer rubber and stretched over the large end of the bar. The new ones are a solid hard rubber with no give at all. Is there a secret to getting these on or do they need to be cut and slipped over the bar? I've watched some youtube videos and they are all cut and easy to install. Grease doesn't help either. Thanks.
  Reply
#2
When I bought an upgraded Addco sway bar from Mustangs Unlimited, the bushings already had a slit in them, as shown below. Seems like they should have a slit in them but if not, I would think you could probably cut one in order to slip the bushing on.

Also if they are polyurethane you need to put some lubricant around it or they will squeak.


.jpg   bushings.jpg (Size: 14.16 KB / Downloads: 37)
  Reply
Share Thread:  


Possibly Related Threads…
Thread Author Replies Views Last Post
  Front Bushing damage when lifting car tfowler9 23 910 09-09-2019, 12:16 PM
Last Post: JD79
  Kickdown Rod Install on Edelbrock 1406 and FMX Rumblefish 3 311 05-10-2019, 02:45 PM
Last Post: Fabrice
  Shaker install Davehoser 7 587 01-20-2019, 04:59 AM
Last Post: luxstang
tach tachometer install markc 14 763 10-04-2018, 07:51 PM
Last Post: markc
runninpony Wiper Motor Install blkulis 3 569 07-25-2018, 04:13 PM
Last Post: Pegleg
  Factory A/C install in a non A/C car who has done it NG8264723 11 2,171 07-11-2017, 11:27 AM
Last Post: Jeff73Mach1
  Install engine with headers on?? Casperfast 4 948 09-04-2016, 07:53 PM
Last Post: Casperfast
  Roller rockers install chefabg123321 7 1,750 01-02-2016, 09:59 PM
Last Post: 4Vforever



Users browsing this thread: 1 Guest(s)