• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Speedo Sensor
#1
How do you get the speedo sensor out of a C4? It has an retainer with 2 fingers on one side and a bolt on the other. I removed that, but the sensor will not budge. Should I pry it out with a screwdriver? It will not even wiggle in the hole.
[Image: 1gq8uo.png]
1971 Mach 1 - 306cid/C4 Bright Yellow
1972 Coupe - 306cid/C4 Gold Glow (in restoration phase)
  Reply
#2
Spray it with p b blaster a couple of times.
It is a slip in fitting with O ring, age and corrosion are holding it in.
Ohio Mustang Supply
440-949-2556

[Image: oms_sig_banner.jpg]
  Reply
#3
With that retainer off it should just slide out. Try some liquid wrench, and then clean around the edges(small flat screwdriver or equiv.). prying might bugger it up.

Mike
  Reply
#4
I hit it with PB Blaster Last Sunday so Maybe it will slide out this weekend!
[Image: 1gq8uo.png]
1971 Mach 1 - 306cid/C4 Bright Yellow
1972 Coupe - 306cid/C4 Gold Glow (in restoration phase)
  Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  HELP Speedo cable clip 73pony 4 492 05-06-2016, 12:38 PM
Last Post: 72HCODE
  oil and temp sensor Mike 3 543 04-20-2015, 07:04 PM
Last Post: Don C
  speedo problems John J 4 708 05-17-2014, 09:27 PM
Last Post: John J
  New speedo cable and gear wrshog 10 1,067 04-16-2014, 09:23 AM
Last Post: CZ-75
  Speedo Gear 71mach429 8 810 05-25-2013, 11:08 AM
Last Post: adm22
  speedo cable removal debs72pony 6 998 11-04-2012, 05:09 PM
Last Post: goodnigh
  speed sensor? ksschraml 1 1,396 06-21-2012, 06:37 AM
Last Post: Tnfastbk
  Oxygen Sensor Anyone Wolverine 2 525 04-05-2012, 07:22 PM
Last Post: c9zx



Users browsing this thread: 1 Guest(s)