71-73 Swag

  • New T-Shirt Design (Also coffee mugs and posters!) – read more!
  • Mach 1 Key Tags available on eBay (Make an offer!) – read more
  • Convertible Key Tags available on eBay (Only 1 more left!!) – read more
  • Coupe Key Tags available on eBay (Make an offer!) – read more

Do staggered shocks affect handling negatively?
1 vote(s)
* You voted for this item. [Show Results]

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
rear shock mount relocation
Okay, so here is the deal. I have staggered shocks from the factory.

I want to unstagger them so as to make more room for a large exhaust system.

I know the cars that did not get staggered shocks did not get the upper mount provision installed at the factory.

So my question is this-do staggered shock cars have the reinforcement plate in place to run the driver side shock in the standard position, or will I have to fabricate that?

I have the lower mount covered with my Caltrac traction bar plates as they have tabs for both.

[Image: 1_01_07_15_8_53_18.png]

"I love my Hookers!" and "Get some Strange" probably have a different connotation to non automotive enthusiasts!
Share Thread:  

Possibly Related Threads...
Thread Author Replies Views Last Post
  72 mach 1 rear sway bar links EvilPuppetMaster 2 234 12-09-2017, 06:22 PM
Last Post: EvilPuppetMaster
  Rear axle ratio... Looking for the calculator or suggestions vikingsandpintos 8 450 12-01-2017, 08:59 AM
Last Post: turtle5353
  Rear end sways when givin gas on a corner Higgins56 15 714 10-13-2017, 08:17 AM
Last Post: Don C
  Rear end (suspension and wheels) 73 Mach 1 12 743 07-12-2017, 08:44 AM
Last Post: mustang7173
  2.75:1 rear axle with limited slip? Vicus 23 1,687 07-07-2017, 05:22 PM
Last Post: jb73Mach
  Big Block into a 6 Cylinder Convertible - Rear Swap? red73mustang 6 631 06-15-2017, 09:09 PM
Last Post: turtle5353
  what are the best types of rear ends? Locker or Posi? Pastorpat 26 1,773 04-15-2017, 10:10 AM
Last Post: cazsper
  rear end leak jpaz 23 1,154 04-13-2017, 11:03 AM
Last Post: jpaz

Users browsing this thread: 1 Guest(s)