71-73 Swag

  • New T-Shirt Design (Also coffee mugs and posters!) – read more!
  • Mach 1 Key Tags available on eBay (Make an offer!) – read more
  • Convertible Key Tags available on eBay (Only 1 more left!!) – read more
  • Coupe Key Tags available on eBay (Make an offer!) – read more

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Radiator Support Replacement
#1
If I can purchase an NOS radiator support vs one made by Dynacorn are there any pros and cons to either?  Are there any benefits to going the reproduction route such as design improvements or anything else?
  Reply
#2
I habe no experience with the dynacorn unit, but i always opt for the real thing over a repro. Just my preference.

1973 H Code Convertible - Medium Copper Metalic - A June 8, 1973, Built Ford Marketing Sales Vehicle
[Image: DSC_0266xsm.jpg]













  Reply
#3
dynacorn  benefits......you can send it back when it doesn't actually fit (I might actually fit)     cons .....time wasted

oe benefits ........it fit......once              cons.........1 hour to 4 months of your time dependent on how bad it is, the work required, coatings, fittings, etc.........that                                                                                   screw/bolt you never knew was there or where it went


rofl Shootself
  Reply
#4
+1 on the OEM support. I installed one in my car and it went very smooth and fit exactly like it was supposed to. Spend the extra $$$ you will not be disappointed.....
Thanks, Jay
  Reply
#5
I think we are all probably in the same place. If there is a new repro it would be best to go for it, unless like a few they are problems and more questions should be asked. If it doesn't work for you then you're only out a little bit of time and not a huge amount of resto. If you cant find it well its going to take resto.
In line with this topic, I've decided to work with the dynacorn repros for drip rail and front and rear glass trim. That is.... until I completely strip, sand mirror finish, and clear a 100% oe set of drip channels, rails, front, rear, and quarter glass trims.
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
runninpony RADIATOR SUPPORT MYSTERY BRACKETS NOT A T5 6 341 11-24-2017, 09:26 AM
Last Post: SVO2SCJ
  Battery Tray Apron Support WINNER Carolina_Mountain_Mustangs 33 2,562 11-04-2017, 11:19 AM
Last Post: rackerm
  NOS Quarter panel replacement dfayette 2 292 10-21-2017, 03:54 PM
Last Post: dfayette
  quarter skin replacement advise Casperfast 39 3,172 07-26-2017, 06:32 PM
Last Post: Casperfast
  73 Front Fender Valance Support Bracket clevelandcoupe 3 555 06-25-2017, 04:48 PM
Last Post: OLE PONY
  front cross member replacement Paul113 11 846 05-15-2017, 08:23 AM
Last Post: mustang7173
  Best fitting aftermarket hood replacement L-60 10 874 12-28-2016, 06:33 AM
Last Post: Tnfastbk
  Replacement Trunk Corners AOCUSNRET 12 1,484 03-17-2016, 03:33 PM
Last Post: Pastel Blue



Users browsing this thread: 1 Guest(s)