• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
NEED HELP ASAP
#1
bulb 
OK folks will the roll up quarter window assemblies from a coupe work in a fastback car? I am making a run to the junk yard in the morning and one there has them.
  Reply
#2
yes you have to grab all the stoppers as well there is a tutorial on here somewhere Don from ohio wrote about it.

hey found it

http://www.7173mustangs.com/thread-fastb...er-windows

ignore what i said in it, i was mistaken at the time about some of the parts differences.
  Reply
#3
Thanks I can buy windows, all mechanicals, and panels for around 60 bucks.
  Reply
#4
This is one mod I really want to do.

Steve



[Image: 25yvyp3.jpg]
  Reply
#5
The interior is still out of mine right now so would be a great time to do it. hopefully in the next few weeks we will be ready for interior.
  Reply
#6
All the coupe parts will fit in, except for the coupe window itself of course. Make sure you get the two coupe upper stops because you will never get the window to correctly seat in the up position without them. Also, get the rear coupe window cranks if you can because they are shorter than the ones in the front. Buy new quarter post rubbers if they are hard because the window needs pliable rubber to slide through properly. Also if the lower outer window strip is hard you may need to trim a small area of it back a little to stop interference. It's a very easy and straight forward swap.

http://www.7173mustangs.com/thread-1971-...n-tutorial

[Image: window19.jpg]

[Image: window20.jpg]

Brett
[Image: stangprofile3.jpg]
  Reply
#7
Flatback72;24699 Wrote:All the coupe parts will fit in, except for the coupe window itself of course. Make sure you get the two coupe upper stops because you will never get the window to correctly seat in the up position without them. Also, get the rear coupe window cranks if you can because they are shorter than the ones in the front.

http://www.7173mustangs.com/thread-1971-...n-tutorial

[Image: window19.jpg]

[Image: window20.jpg]

Thanks
  Reply
Share Thread:  




Users browsing this thread: 1 Guest(s)