• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
midplate
#1
Hello everyone good to be back. Have a question about the midplate. I am changing over from a C6 to a C4. Have everything bolted up finally and
find out that the starter bolt hole on the plate do not line up with the trans. My question is there a difference in the midplate  between a C4 and a C6
Thanks 
Jim

drive it like you stole it
  Reply
#2
There is, depends on if you're running a 157th bell/flexplate combo on the C-4, or a 164 tooth.

Small block C-6 were all 164 tooth. C-4 could be 157 or 164, depending upon original application, year etc.


  Reply
#3
(02-17-2019, 12:12 PM)coilwire Wrote: Hello everyone good to be back. Have a question about the midplate. I am changing over from a C6 to a C4. Have everything bolted up finally and
find out that the starter bolt hole on the plate do not line up with the trans. My question is there a difference in the midplate  between a C4 and a C6
Thanks 
Jim

Hemikiller the C6 was 164 tooth. The flexplate on there now is the 157 tooth. Thanks for the info.
Jim

drive it like you stole it
  Reply
Share Thread:  




Users browsing this thread: 1 Guest(s)