• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
low oil pressure or bad sensor or something else
#1
Wrench 
My oil pressure has been different lately and I am not sure why. Its used to read 3/4  to high and then drop to mid point when the engine warmed up. Now it reads 3/4 to high  but will drop down to nothing once the car warms up. The sensor is about 4 years old. I did pull the wire off and clean the post. That didn't make a difference. I have a extra sensor so I will change it out next. Car starts and runs fine. oil level on the dip stick is good.   The only work I did to the engine was changed out the valve cover gaskets.


Thanks


John
  Reply
#2
I have a mechanical oil pressure gauge that I use for these situations, along with a variety of fittings, that I have had for many years.

You can get a gauge kit at Harbor Freight:
https://www.harborfreight.com/engine-oil...62621.html

A mechanical gauge shows minor fluctuations in real time. Useful for spotting worn bearings, especially main bearings, when there's a lot of change from acceleration to deceleration.



“If you can't explain it simply, you don't understand it well enough.”
--Albert Einstein
  Reply
#3
yes put a pressure gage on it to be sure.. but if hot idle and no valve tapping then good chance not the pump but gage or sending unit.
  Reply
#4
Make sure you pay attention to the fuel gauge and temp gauge when you see the oil pressure fluctuate. If the other gauges move in time, could be a constant voltage regulator issue

[Image: image.jpg]

Dennis
  Reply
Share Thread:  


Possibly Related Threads…
Thread Author Replies Views Last Post
  Clearances and oil pressure OzCoupe72 28 1,375 08-21-2019, 10:30 PM
Last Post: Spike Morelli
  Oil pressure drop 6DUB606 6 619 04-09-2019, 07:26 PM
Last Post: Hemikiller
  underhood gauge - oil pressure SteveO_71 3 381 02-18-2019, 09:39 AM
Last Post: SteveO_71
  Sensor on vacuum line Q code John J 1 598 06-10-2018, 03:49 PM
Last Post: Don C
  Oil Pressure Gauge Reading JD Wright 8 1,592 11-16-2017, 10:48 AM
Last Post: Stanglover



Users browsing this thread: 1 Guest(s)