• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
looking
#1
I am looking for a thread that was posted in the last few days on welding. The thread gave tips on wire feed and heat settings. Like a dummy I did not put it in my favorites.Undecided
Jim
  Reply
#2
I think you may be talking about this one. Basic MIG welding 101. It's in the maintenance and repair forum Page 2 by 72 fastback. Mark
My garage http://www.7173mustangs.com/forum-garage...rxt_uid=40

73 mach 1 351c 4v cc ported, torker2, 750 edelbrock,C6.
73 fastback 351c 2v,performer intake,600 edelbrock,fmx, 325 trac-lok.
  Reply
#3
(01-10-2011, 09:41 AM)machman_73 Wrote: I think you may be talking about this one. Basic MIG welding 101. It's in maintenance and repair forum by 72 fastback. Mark

If so, this is the link:

http://www.7173mustangs.com/thread-basic...ht=welding
[Image: 1gq8uo.png]
1971 Mach 1 - 306cid/C4 Bright Yellow
1972 Coupe - 306cid/C4 Gold Glow (in restoration phase)
  Reply
#4
(01-10-2011, 09:41 AM)machman_73 Wrote: I think you may be talking about this one. Basic MIG welding 101. It's in maintenance and repair forum by 72 fastback. Mark

http://www.7173mustangs.com/thread-basic...ht=welding
73 conv. 460, D0VE large valve heads, Performer RPM manifold, Voodoo 227/233 cam, Holley 950 HP carb, C6 trans, 3.25 trak-loc.
  Reply




Users browsing this thread: 1 Guest(s)