• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fuel Line
#1
I keep crimping the steel fuel line tring for some tight bents. I don't like it but is plain rubber fuel line safe along the manifold like from the dist. to the carb. I my look for a breaded cover for protection.. Any Ideas????

Alan L

[Image: 1_30_09_13_10_12_32.png]
Alan L
  Reply
#2
Rubber in lengths shorter than 6" or so is fine. I read an article recently that recommended using "high pressure" hose as it is more resistant to todays fuels.

Jeff T.

Low buck, touring style, '73 Convertible "rolling restoration", 351c, 2v heads with a shave and a haircut, Performer intake, Holley 650(ish), roller rockers, screw in studs, guideplates, stainless valves, Duraspark / Motorsports MSD, T-5 conversion. 1-1/8" front, 3/4" rear swaybars KYB shocks and some home brewed subframe connectors. Future plans; JGC steering box, Cobra brakes and... paint, interior, etc.

When I die I want to die like grandpa, peacefully in my sleep... not screaming, like his passenger.

[Image: 1_12_09_14_10_15_11.png]
  Reply
#3
I ran a metal line up from the fuel pump. Are you using tubing benders?
  Reply
#4
Broke one tube bender, then used spring bender. Should by new bender Dodgy

[Image: 1_30_09_13_10_12_32.png]
Alan L
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Removing fuel tank and not blowing up Vinnie 15 542 01-28-2019, 08:05 AM
Last Post: Fabrice
  Use of Fuel Stabilizer goodnigh 13 412 01-25-2019, 04:32 PM
Last Post: Stanglover
  Fuel vapor separator asusnz 13 3,216 01-09-2019, 04:42 PM
Last Post: tawod
Wrench Fuel sender alignment Ballaratcastle 8 358 12-09-2018, 07:42 PM
Last Post: Ballaratcastle
  routing of gas line at tank rjpohl 8 325 11-13-2018, 07:14 PM
Last Post: Stanglover
  vacumn line and thermal switch naa10104 3 409 07-09-2018, 07:04 PM
Last Post: naa10104
  No fuel can't start. mweeps 1 410 05-19-2018, 11:38 AM
Last Post: Don C
  fuel sending unit pedstagn71 1 335 05-13-2018, 04:44 PM
Last Post: Don C



Users browsing this thread: 1 Guest(s)