• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ford FMX
#1
Hello Mustang World. So here is my problem. I have a 72 mustang convertible with a 302 and FMX tranny. I picked it up last year and it seemed to have lost 2nd gear. In my infinite wisdom I had paid a guy some money, who apparently purchased a used FMX on Ebay, splashed some fresh fluid in it and away I went. It got home fine. I was excited.. I am in the military and had to go away for a while. Just returned home and in my garage I have a very large puddle of what could be type F. So, does anyone here have an FMX that is not currently leaking that could use a new home in NH or do you suggest that I take on the challenge of a self rebuild. I say self rebuild because I have called a few tranny shops and they have all virtually said the same thing. Sales speech, " well it's an old iron tranny" expensive"blah" blah". Not sure who or what they take me for, but the want 2k plus. I was born at night, but not last night. So, any suggestions?
  Reply
#2
(02-24-2019, 08:02 PM)Cmdr18 Wrote: Hello Mustang World. So here is my problem. I have a 72 mustang convertible with a 302 and FMX tranny. I picked it up last year and it seemed to have lost 2nd gear. In my infinite wisdom I had paid a guy some money, who apparently purchased a used FMX on Ebay, splashed some fresh fluid in it and away I went. It got home fine. I was excited.. I am in the military and had to go away for a while. Just returned home and in my garage I have a very large puddle of what could be type F. So, does anyone here have an FMX that is not currently leaking that could use a new home in NH or do you suggest that I take on the challenge of a self rebuild. I say self rebuild because I have called a few tranny shops and they have all virtually said the same thing. Sales speech, " well it's an old iron tranny" expensive"blah" blah". Not sure who or what they take me for, but the want 2k plus. I was born at night, but not last night. So, any suggestions?
If you are mechanically inclined, the FMX is a fairly straight forward transmission to rebuild.  Kenneth Collins of Bad Shoe Productions sales a step by step video series that walks you through disassembly and rebuild of the transmission, as well as sells some ofthe specialty tools needed for the rebuild.  I rebuilt the FMX in my 69 Mach 1 and 73 Mach 1 this past year using his video and clutch compressor tool.  I believe he is selling the rebuild kits as well.  I was able to rebuild both transmissions, with parts, convertors, bands and all for less than I was quoted for 1 rebuild.

It is worth the effort, if you can do it.
  Reply
#3
https://www.broaderperformance.com/

Jay has rebuilt many FMX transmissions. Might be an option.
  Reply
#4
my question is ... where is it leaking from ????? front/rear seals are easy to replace. oil pan gasket is easy too. u could have a bad O'ring on the dip stick tube and that's easy.
i'll say the front seal u do need to pull the trans to do it. but with any of the above u are talking less then 1/2 hr a do it yourself. more time for front seal.
if u don't see where it's leaking then clean the trans with brake fluid and refill and drive again. if it leaked once it'll leak again.
  Reply
#5
Aside from the above mentioned dipstick oring There is also a seal on the shift linkage bell crank lever that often leaks and could be changed with trans in place.
FMX are very durable, try to fix the leak and see if it runs.
Troubleshoot the issue before rebuilding, last thing you need is to rebuild it and have the same problem again.

If you had a problem with the other one not shifting to second gear, sometimes the governor gets clogged with junk. There is a small screen there, you can access it by removing the tail shaft.

I think $2000 is too much, it’s a simple transmission compared to the newer ones.
Good luck

[Image: mustangnight010.jpg]
1972 Mustang Convertible 351C 4V
1966 Ford Galaxie 7 litre-4speed

Jorge
  Reply
#6
I kept reading the forum and saw this

https://www.7173mustangs.com/thread-fmx-...ent-how-to
  Reply
#7
Yeah, seems like your best bet is to first determine if that is actually trans fluid on your floor. Fill the trans and run the car, try to isolate the source of the leak. If the trans operates fine otherwise you just have to fix the leak. Could it be as easy as a leaky pan gasket? It's a shame if your second gear issue with the original trans was an easy fix, but that ship has sailed.
  Reply
Share Thread:  


Possibly Related Threads…
Thread Author Replies Views Last Post
  1973 FMX transmission conversion JULIENHATSWELL 9 556 05-21-2019, 07:32 AM
Last Post: Omie01
  Ford vs CHI vs AFD vs TFS heads for Stroker mikeyhunts 15 799 04-12-2019, 02:50 PM
Last Post: mikeyhunts
  9" Ford oil capacity - confused! tony-muscle 10 446 04-03-2019, 10:42 AM
Last Post: Jeff73Mach1
  FMX or C6 Bigdibbs88 10 601 04-02-2019, 12:41 PM
Last Post: 1sostatic
  B&M Megashifter with FMX done :-) Robsweden 9 1,102 03-04-2019, 04:50 AM
Last Post: Dcueva88
Wrench Ford 302 Main Cap bolts Stang1972 4 449 01-11-2019, 10:56 AM
Last Post: c9zx
  FMX / Kickdown return spring? Bentworker 4 683 10-03-2018, 11:30 AM
Last Post: Fabrice
  FMX to C4 Automatic Transmission fangstang 7 1,229 09-17-2018, 12:44 AM
Last Post: Studdley



Users browsing this thread: 1 Guest(s)