• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FMX to C6 conversion
Hi Guys,

well I have a question about the shift rod what goes from my 351C to my C6 trans, a couple of years ago I had to change my tranny from an FMX to a C6 and had not the shift rod for the C6, so I installed the FMX one.
Unfortunately I could not exactly adjust the gears with this one.

Is there a difference between those rods or is there any thing I miss or don't know?

Thanks for your answers.

Yes they do use differant shift rods. The C6 has a specific rod.

[Image: 16kuyc0.jpg]
Yes, I had the same problem. I am also not sure that the C6 I got came from a mustang. What I had to do was lengthen the tranny linkage (the part on the transmission) to make it work.

73 Convertible - 351C/4V CC heads/4bolt/forged flat tops/comp 270/rhodes/mallory unilite/tri-power/hookers/glasspacks/c6/3.50 limited slip/Gear Vendors/Global West sub frames, strut rods and shelby style traction bars/ Rear sway bar/tilt steering (not original)

Pics of modifications included in:
I did the same conversion and the FMX shift rod worked fine with the c6. I did have to modify the kickdown linkage a little though.
Share Thread:  

Possibly Related Threads...
Thread Author Replies Views Last Post
  FMX Fluid Inlet and Outlet Location VasiliBrown 2 113 07-12-2018, 08:04 AM
Last Post: Don C
  Fmx shift shaft seal replacement Tucaz520 11 486 06-29-2018, 05:13 AM
Last Post: summerboy
  FMX Seal Change Mac 0 118 06-25-2018, 11:50 AM
Last Post: Mac
  Can FMX be removed from car without dismounting exhaust? Spechti 4 322 05-11-2018, 11:12 AM
Last Post: Spechti
  FMX Transmission casting number question? Monterey 6 403 03-01-2018, 11:45 AM
Last Post: Vicus
  5-speed conversion questions scgamecock 7 688 01-11-2018, 08:46 PM
Last Post: Pastorpat
  71 C4 into 72 that had FMX vikingsandpintos 2 324 11-08-2017, 12:09 PM
Last Post: vikingsandpintos
  Holley Sniper EFI and RobbMC Surge Tank, 351c and FMX NewAgeMuscle 108 9,798 08-28-2017, 02:43 PM
Last Post: Fabrice

Users browsing this thread: 1 Guest(s)