• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Equalizer Bar install problem
#1
This past Saturday I installed a 351C and toploader into my 71' Mach 1   I purchased an aftermarket equalizer bar, as well as a new nylon bushing and felt seal that attaches to the inner bracket that mounts onto the block.
The issue I am having is the bottom hole on the inner bracket does not align with the hole in the bell housing. It is about 3/8 of an inch off.
The nylon bushing that slips onto the inner bracket fits loose. I would think it would have a snugger fit. What I think is the issue is the felt seal that sits behind the bushing, between the inner bracket and equalizer bar, is too thick. Perhaps someone produces a rubber seal that would fit better. I've attached a couple of photos.
This is my first time attempting a project like this. Any help or guidance is appreciated. 

Thanks[Image: IMG-8464.jpg][Image: IMG-8463.jpg]
  Reply
Share Thread:  


Possibly Related Threads…
Thread Author Replies Views Last Post
  Restarting problem Danno 7 382 09-08-2019, 09:16 AM
Last Post: Don C
  3 speed manual trans problem 48Ford 1 277 08-22-2019, 10:43 AM
Last Post: Carolina_Mountain_Mustangs
  Header install jpaz 18 977 04-26-2019, 12:22 PM
Last Post: jpaz
  Got another problem 351c batwrangler 26 1,884 02-15-2019, 07:48 PM
Last Post: batwrangler
  Pinion Angle Problem? CoolCat33 8 678 01-28-2019, 08:50 AM
Last Post: Jeff73Mach1



Users browsing this thread: 1 Guest(s)