• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
engine issues?
#1
If you do not mind, my Cleveland as upgraded w/solid lifters w/H.O. Lunati cam and 9.5 compression, and only 2800 miles after the overhaul as well w/the Ford toploader but for some reason, and issue arised with oil pressure increasing immensely since AC after market 'Hurricane' installed, some squealing of belts though oil looks clean, w/couple of years on it, think the viscosity has broken down however did run into a little hiccup with running an attempt in a 1/4 mile but did not change gears from 1st to 2nd until it reached, 58mph w/7200 rpms and 'what a backfire from it. Not a noticeable leak from anywhere however looking at taking it in for a gasket refitting. and maybe rear end seal needing attention a little bit. what do you think(possibly a clogged pick up)? not too experienced at this........<:+?> "Think I will have it towed from place where look into belts and then over to have engine gasket fixed
then amidst change over from 2 barrel intake manifold to a 4 barrel 'air gap' to replace it then that XADO additive into the 'soup', ;per se.

[Image: 1_12_09_14_11_07_03.png]
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Headers to fit '72 Mach 1 w/400 engine MeanMachine 7 177 7 hours ago
Last Post: donkost
  Post your burbling bit (Engine) 1sostatic 3 153 Today, 08:52 AM
Last Post: Robsweden
  351c starting & driving issues n_reckless 12 422 02-28-2019, 10:42 PM
Last Post: kcmash
  351C 4V - 72 Mach 1 Engine fan baz70 16 488 02-21-2019, 09:13 AM
Last Post: Stanglover
  Engine/dyno/speed programs mbrew2 3 211 02-03-2019, 09:28 AM
Last Post: c9zx
  302 engine identification & specs rjpohl 5 287 01-10-2019, 08:22 PM
Last Post: Hemikiller
  pull engine and trans as a unit? scgamecock 46 1,299 11-28-2018, 02:36 PM
Last Post: Fabrice
  engine oil Driven HR1 15W50 Nige 10 476 11-27-2018, 02:41 PM
Last Post: Fabrice



Users browsing this thread: 1 Guest(s)