• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
end of rear rocker panel pictures
#1
Anyone have some good pics of what the rear of the rocker panel looks like ? I have repaired mine and fabricate it all by hand , I put a new quarter panel on and dont have enough of the rocker left to see what it is supposed to look like? Pics of the inside where the wheel well and rocker meet. Any help would be appreciated. This picture shows the new quarter and the lip of the outer wheel well , thats the area i need to create the end lip if that makes any sense?    
  Reply
#2
   

Here you go, hope it helps.
Thanks, Jay
  Reply
#3
a Bit any from rear and bottom up? or From inside out,

Thanks
  Reply
#4
   
83slimer;241963 Wrote:a Bit any from rear and bottom up? or From inside out,

Thanks
Hi,
Here's a few pictures of my rebuilt rocker panel ends. The ends around the trim holes had lots of rust pin holes in them. I fabricated new ones and welded them in.

Michael


Attached Files Thumbnail(s)
                               
  Reply
#5
Perfect just what i was looking for , I fabricate all my own parts I replace so now I see the angles and contour lines, thanks for the detailed pictures.!!!
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Preparation for the Rear End jt.db 4 181 Yesterday, 06:25 PM
Last Post: vintageman
runninpony Dynacorn 1/4 panel NOT A T5 5 286 09-16-2018, 05:57 AM
Last Post: NOT A T5
runninpony rear frame rail rust NOT A T5 5 443 07-04-2018, 03:17 PM
Last Post: Mister 4x4
  Tail light panel honeycomb fasteners. turtle5353 23 2,560 06-03-2018, 09:07 PM
Last Post: Boss1Ray
  Rear bumpers Studdley 2 438 05-09-2018, 10:09 AM
Last Post: Studdley
  Taillight PANEL CENTER BRACE MOUNT vintageman 6 488 04-26-2018, 08:25 PM
Last Post: vintageman
  left side rear floor extension vintageman 2 339 04-08-2018, 10:46 PM
Last Post: vintageman
  plastic fender to cowl filler panel trim information mach1000 6 588 03-13-2018, 08:37 AM
Last Post: mach1000



Users browsing this thread: 1 Guest(s)