71-73 Swag

  • New T-Shirt Design (Also coffee mugs and posters!) – read more!
  • Mach 1 Key Tags available (almost gone!) – read more
  • Convertible Key Tags available (limited supply) – read more
  • Coupe Key Tags available (only a few left) – read more

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dumb question here
started to change fuel filter yesterday and noticed the rubber line to carb was solid as a brick no give to it, took clamp off of filter and the fuel shot about 7 feet and emptied the the line from carb and some out of bowl from the amount that came out,( under a lot of pressure ) i have never really been an Edelbrock guy always ran Holley and never ran into this before. any ideas?

[Image: 2zdx09d.png]
Yea,Tho i cruise through the valley of the shadow of rice,I will fear no Turbo,For Torque art with me.Thy rods and crankshaft,they comfort me. Big Grin Robert
Sounds like the needle, seat and check valve in the pump (if equipped) are in good shape and doing their job.
If it's not running rich, I wouldn't mess with it.

Pete - MotoArts Decals and Signs
'71 Sportsroof 351C-4V/4-speed - FINALLY under construction - no, wait, on hold again...
'90 Mustang 7-Up 5.0 ragtop, rolling beater
'66 Sunbeam Tiger Mk.IA, survivor
Gas with 5#-6# PSI on it will shot along way.
Share Thread:  

Possibly Related Threads...
Thread Author Replies Views Last Post
  351C Stroker / TKO 600 bellhousing question tony-muscle 11 724 03-29-2018, 03:18 PM
Last Post: tony-muscle
  FMX Transmission casting number question? Monterey 6 204 03-01-2018, 11:45 AM
Last Post: Vicus
  ok probably dumb question but...... libram 8 497 01-09-2018, 10:41 PM
Last Post: rotorr22
  Non flapper ram air question cigarguy 8 572 11-14-2017, 11:17 PM
Last Post: cigarguy
  Last ram air question i promise eventhorizon 5 599 07-18-2017, 12:36 PM
Last Post: jowens1126
  Engine vacuum question eventhorizon 9 738 07-16-2017, 06:20 PM
Last Post: midlife
  1972 ram air question eventhorizon 2 539 07-05-2017, 09:05 AM
Last Post: eventhorizon
  Comp Cams Hydraulic Roller Conversion question 73pony 31 2,146 06-08-2017, 06:07 AM
Last Post: turtle5353

Users browsing this thread: 1 Guest(s)