• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Door panel, lock knob
#1
I have to drill a hole in the new door panels for the lock rod to pass through. The question is exactly where to drill the hole. Does anyone have an original door panel that you could take some measurements from? Maybe from the back edge of the panel to the center of the hole and from chrome edge to the center of the hole (deluxe door panels). Obviously this is a one shoot deal so all help would be appreciated.

Thanks, Chuck
  Reply
#2
Hi Chuck,

Just went outside and measured it. On my deluxe door panels it's 90mm from the rear edge and 15mm from the chrome trim on the driver side. On the passenger side it's again 90 mm from the edge but only 12mm from the chrome trim, so I guess 100% accuracy is not needed.
Sorry for the metric measurements but that's all I have here at the moment.

[Image: 1z21rv4.png]

Mike

"If I were you...... I´d rather be me."  Tongue

Check out my video:
http://www.7173mustangs.com/thread-my-mustang-in-action

  Reply
#3
Here is a really neat, free program that sits on your desktop..it converts just about anything.
http://joshmadison.com/convert-for-windows/
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Interior Quarter Panel screw JimB73 7 353 10-19-2018, 05:20 PM
Last Post: JimB73
  Door Sound/Heat Deadening EdM 8 352 10-14-2018, 04:39 AM
Last Post: goodnigh
runninpony LH Dash Trim Panel NOT A T5 0 159 09-03-2018, 07:54 AM
Last Post: NOT A T5
  Mach1 - interior upper rear panel to rear window Engine302 13 784 08-31-2018, 01:41 PM
Last Post: Mister 4x4
  door guts Copestang 9 585 08-24-2018, 10:52 PM
Last Post: batwrangler
  Dash end panel oddity Pegleg 2 405 07-03-2018, 10:55 AM
Last Post: donkost
  Door Jamb Vent Covers ITMike5.0 7 610 05-03-2018, 04:09 PM
Last Post: Mikes73
  Hood lock install Jeff73Mach1 37 8,753 04-25-2018, 03:22 PM
Last Post: Jeff73Mach1



Users browsing this thread: 1 Guest(s)