• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Back from the platers
#1
I am in the process of tackling the heater/AC. Sent the blower motor wheel (hamster wheel) off to the platers. Before it went off the rust was covered around 25% of the wheel. Now though its looking brand new. Very happy with the final result. The doors and rods have also gone to platers. Will post pics when i take them

[Image: 20180725_110608.jpg]


[Image: 20180725_110623.jpg]

Plus new seal kit

[Image: 20180725_110659.jpg]

Steve
1971 Grandé
  Reply
#2
(07-25-2018, 05:27 AM)Pegleg Wrote: I am in the process of tackling the heater/AC. Sent the blower motor wheel (hamster wheel) off to the platers. Before it went off the rust was covered around 25% of the wheel. Now though its looking brand new. Very happy with the final result. The doors and rods have also gone to platers. Will post pics when i take them

[Image: 20180725_110608.jpg]


[Image: 20180725_110623.jpg]

Plus new seal kit

[Image: 20180725_110659.jpg]

Steve, That looks great! Nothing looks better than a newly plated part. Make sure you balance it. I had one that lost its counterweight and it made a loud noise when spun at high speed.
  Reply
#3
Thanks Rackerm. Didnt even consider it needed balancing

Steve
1971 Grandé
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Putting the Motor and trans back in 73pony 7 810 05-19-2017, 01:05 PM
Last Post: tony-muscle
  seat back release 73 vert John J 5 800 05-13-2016, 07:04 PM
Last Post: secluff
  Back up lights not working tatkinson@yousq.net 13 1,617 04-09-2016, 08:36 PM
Last Post: midlife
  Back seat floor clips clonetroop211 13 1,711 07-22-2014, 08:41 AM
Last Post: OMS
  gap in the convertible top and back window gsmaggot 9 2,094 09-25-2012, 01:25 PM
Last Post: Bill73Ragtop
  back up lights not2old 3 969 03-04-2012, 11:37 PM
Last Post: Don C
  OMG, I am back Fordication 7 1,369 12-07-2011, 05:45 PM
Last Post: marks73
  Carb back from Pony Carbs Sprintsportsroof 14 3,477 11-30-2011, 01:25 AM
Last Post: canadian_red_maple_leaf



Users browsing this thread: 1 Guest(s)