• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
460 or 351 Fan blade?
#1
Well, I finally found a fan shroud but it's for a 1973 Mustang with the 351 and I have a 460 installed in my 73. Now I need to find a fan blade. What would you suggest? Should I look for a fan blade for a 429-460 or a 351? I don't think the 351 blade will fit over the water pump shaft of the 460 but if I go with a 429 or 460 blade it might not fit within the shroud. Wonder if they make an adapter?
  Reply
#2
Robnbama;157407 Wrote:Well, I finally found a fan shroud but it's for a 1973 Mustang with the 351 and I have a 460 installed in my 73. Now I need to find a fan blade. What would you suggest? Should I look for a fan blade for a 429-460 or a 351? I don't think the 351 blade will fit over the water pump shaft of the 460 but if I go with a 429 or 460 blade it might not fit within the shroud. Wonder if they make an adapter?

Ream or drill the 351C fan to 3/4". That's what I did.

73 conv. 460, D0VE large valve heads, Performer RPM manifold, Voodoo 227/233 cam, Holley 950 HP carb, C6 trans, 3.25 trak-loc.
  Reply
#3
+1 on the re-drill. I did it too !!!
Thanks, Jay
  Reply
#4
Thank guys...just ordered the fan
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Check Your Fan Assembly Blades kingb1973 10 413 09-06-2018, 11:53 AM
Last Post: secluff
  351 Cleveland Heads Reinstallation bigfoot72 2 158 09-02-2018, 09:28 AM
Last Post: mudbilly
  Anemic 351-C 2V KT-69 44 6,747 08-28-2018, 07:01 PM
Last Post: Mister 4x4
  1973 351 H code vacuum routing Mikes73 6 4,818 08-10-2018, 05:12 PM
Last Post: scottyrocks
  1973 351 C running hot issues Carolina_Mountain_Mustangs 27 997 08-08-2018, 10:28 AM
Last Post: Carolina_Mountain_Mustangs
  Cracked 351 Cleveland Heads bigfoot72 29 1,702 05-26-2018, 12:37 AM
Last Post: barnett468
  What goes into a 460 swap? cazsper 27 11,113 05-05-2018, 12:39 PM
Last Post: Ron Tanzi
  Electric Fan(s) and Fuel Pump Recommendations EdM 8 674 03-21-2018, 02:17 PM
Last Post: mustang7173



Users browsing this thread: 1 Guest(s)