• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1973 Non-Staggered Shocks Rear Sway Bar Installation
#1
Guys,
Doing a gear change, rear end housing weld repair and general clean up under the back end. I purchased a used rear sway bar and want to install. Would anyone have a few photos of plates installed by leaf springs, my units are all painted and I cannot figure out which one goes where.
Thanks, Jay
  Reply
#2
The flange for the sway bar link should orient forward of the axle housing, outside of the spring. The holes in the plates are not in a square pattern, so they will only fit one way. Some pics on the 429 Megasite linked below.

http://www.429mustangcougarinfo.50megs.c...ension.htm


  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Replacement rear window/ trunk filler panel. New72 5 141 05-14-2019, 11:59 AM
Last Post: New72
  Removing rear quarter window glass and surrounds baz70 7 248 04-28-2019, 01:55 PM
Last Post: baz70
Wrench Rear Quarter Panel Repair Sanity Check 1973_Mustang_Conv 7 320 04-06-2019, 09:24 PM
Last Post: turtle5353
  Rear window install Al rumble 2 158 03-28-2019, 09:25 AM
Last Post: Carolina_Mountain_Mustangs
  grille trim removal and installation rjpohl 7 479 02-13-2019, 08:47 AM
Last Post: mustang7173
  Rear Window sealI keiths71 12 600 01-07-2019, 01:56 PM
Last Post: OMS
  Mach1 rear bumper tawod 10 664 12-17-2018, 08:31 AM
Last Post: OMS
  1970 vs 1971 rear frame garrett7 2 395 12-13-2018, 05:53 PM
Last Post: Mister 4x4



Users browsing this thread: 1 Guest(s)