• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Interior rear trim pieces
#1
Okay need some Help!

I have a '72 mach 1 fastback. I'm redoing the interior. Installing headliner & sail panels. There is a trim piece that goes over the bottom of the sail panel & just above the package tray. Can't find my originals. The interior was pretty ragged when I got the car. I have been looking for the past several days and have talked to several suppliers. Seems like this panel is not available. Need some help to find either some used ones or a least a pattern so that I can make some. Someone usually comes through.

Thanks,
Desperate in Louisiana
Jimmy T.
  Reply
#2
Jimmy, you're correct the part you're looking for isn't available as a reproduction. I checked every where and Don from OMS posted a great recommedation on creating your own just a few days ago. My old plastic panels were sun warped so I used 1/8 type pressboard type material from Home Depot, cut my own, then used the same low profile carpet on my read deck (bought the low profile car carpet piece from Walmart for $8.00) to cover them. Used loctite spray adhesive to bond it to pressboard. Redoing my rear deck and replacing the the piece you're talking about cost me about $25.00 for everything.

.jpg   panels1.jpg (Size: 103.77 KB / Downloads: 55)

Jimmy as a side note, Don had recommended possibly using headliner material to cover the part, I didn't have any so used the low profile carpet I had left over after doing my rear deck cover. I do believe the using the headliner material would look better but I didn't have any and just wanted to get it done. The carpet isn't the best but I figure as long as I don't spill to many beers on it, it'll hold out fine. The board I used it a Medium-density fiberboard (MDF)

Jim

Jim

M code 71 Mach 1, 351 4V Cleveland, Ram Air (not factory), C6 Trans, 3.5 rear
  Reply
#3
Jim and Jutta;59183 Wrote:Jimmy, you're correct the part you're looking for isn't available as a reproduction. I checked every where and Don from OMS posted a great recommedation on creating your own just a few days ago. My old plastic panels were sun warped so I used 1/8 type pressboard type material from Home Depot, cut my own, then used the same low profile carpet on my read deck (bought the low profile car carpet piece from Walmart for $8.00) to cover them. Used loctite spray adhesive to bond it to pressboard. Redoing my rear deck and replacing the the piece you're talking about cost me about $25.00 for everything.


Jimmy as a side note, Don had recommended possibly using headliner material to cover the part, I didn't have any so used the low profile carpet I had left over after doing my rear deck cover. I do believe the using the headliner material would look better but I didn't have any and just wanted to get it done. The carpet isn't the best but I figure as long as I don't spill to many beers on it, it'll hold out fine. The board I used it a Medium-density fiberboard (MDF)

Jim


Jim,

Any chance you made a pattern? Could use one.

Thanks,
Jimmy t.
  Reply
#4
[/quote]


Jim,

Any chance you made a pattern? Could use one.

Thanks,
Jimmy t.


I used the old warped ones as a template, probably not concours quality Cool but it's 70's correct.

Jim

M code 71 Mach 1, 351 4V Cleveland, Ram Air (not factory), C6 Trans, 3.5 rear
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Misc. Exterior and Interior Odds/Ends icejawa 15 355 3 hours ago
Last Post: icejawa
  Mach 1 rear valance ChrisH 22 697 08-09-2018, 09:21 AM
Last Post: Carolina_Mountain_Mustangs
  Avocado Interior 67aj 10 410 07-21-2018, 10:55 AM
Last Post: Carolina_Mountain_Mustangs
  smoke rear glass Copestang 8 346 06-28-2018, 07:53 AM
Last Post: mustang7173
  72 mach 1 rear seat swap 4kMach1 0 236 05-28-2018, 11:17 AM
Last Post: 4kMach1
  interior paint jiujitsuDave 5 1,581 05-21-2018, 10:29 AM
Last Post: Carolina_Mountain_Mustangs
  Interior dashboard removal step by step.... baz70 22 10,963 04-30-2018, 06:17 PM
Last Post: Mister 4x4
  Rear Bumper Twins 28 1,197 04-27-2018, 03:10 AM
Last Post: stormy69



Users browsing this thread: 1 Guest(s)