• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
vaccum Pictures
#1
I am looking for a few people to post some photos of your engine so I can see where some of the lines go. I will take some photos so you can see what I am dealing with. I have vaccum and wires that are lose, and I know that I changed my intake and carb but most of these should work.

I am also looking for a few ideas on what type of air cleaner I can roll with since I have that hei and it is to tight to get my factory cover on. Thanks


STANG OUT

1973 MACH ONE H CODE "RUSS"
  Reply
#2
There are diagrams available. Probably better than pictures.

'Mike'
73 Convertible - 351C/4V CC heads/4bolt/forged flat tops/comp 270/rhodes/mallory unilite/tri-power/hookers/glasspacks/c6/3.50 limited slip/Gear Vendors/Global West sub frames, strut rods and shelby style traction bars/ Rear sway bar/tilt steering (not original)

Pics of modifications included in:
  Reply
#3
well the problem I am having with my diagrams is that the are older one and since I updated both carb, dist, adn intake I am having to rewire do to them. I was just hoping I would get a few pictures to roll with no big deal either way.

1973 MACH ONE H CODE "RUSS"
  Reply
#4
Need to know what model carb and dual or single vacuum advance distributor.
Also, does the water pump have a vacuum control switch?

mike

[Image: 1_11_11_13_11_50_27.png]
  Reply
#5
I will get the pictures loaded. Carb is a 600cfm Edler I should only have a single. I think the piece you are talking about I took a picture of it and I will see if it is. Thanks I will get them on soon

1973 MACH ONE H CODE "RUSS"
  Reply
#6
here are two wire on the Driver side that are loose in pic one the 2 pic is the pass side with the vacuum
not sure where any of these go
this is the pass side and again I am lost go figure


Attached Files Thumbnail(s)
           

1973 MACH ONE H CODE "RUSS"
  Reply
#7
rentascout;59048 Wrote:here are two wire on the Driver side that are loose in pic one the 2 pic is the pass side with the vacuum
not sure where any of these go
this is the pass side and again I am lost go figure


I can help with picture 2

http://www.7173mustangs.com/thread-under...trol-valve

Blanked mine off as it doesnt get too warm here

Big Grin


  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Front pictures of assembled 351C timachone 2 698 05-29-2015, 05:16 AM
Last Post: timachone
  MDL Clutch Pedal Pictures? Augie 6 919 01-24-2015, 12:49 PM
Last Post: Augie
  Vaccum lines at air plenum; Tachometer tony-muscle 16 2,441 09-19-2014, 07:35 AM
Last Post: Bill73Ragtop
  Pictures of brackets needed NoLimitssjca 3 990 10-21-2012, 10:32 AM
Last Post: Mister 4x4
  pictures of new cleveland block c9zx 3 999 10-19-2012, 07:03 PM
Last Post: c9zx
Wrench T5 cable clutch question - Pictures! whitelouis 14 6,551 03-11-2011, 02:37 AM
Last Post: whitelouis



Users browsing this thread: 1 Guest(s)