• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Oil pan?
#1
I am working on the engine for my 71 mustang. I thought I had everything I needed to put it all together. (the engine) I was wrong. I had an "extra" oil pan in the garage, and so I cleaned it, stripped it, scraped it, and painted it. Then today, when I tried to bolt it on, I found out that I had a nice example, of what I wanted to replace!

So now I'm looking for a new pan. The point of this though, is "what do you do/use to fill the hole in the side of the block, where the dip stick tube goes into the pan?"

Is there a common, easy cheap solution to getting rid of that extra hole?
  Reply
#2
what engine do you have I have a stock oil pan for a 351c that I am not using. It has a few bumps but was not leaking when I took it off the car. I have a bigger milodon oil pan now so it's up for grabs. I can take a few pics for you if you want.

Eric


[Image: a58hgh.jpg]
DRIVE IT DON'T STORE IT!
  Reply
#3
72fastback;24385 Wrote:what engine do you have I have a stock oil pan for a 351c that I am not using. It has a few bumps but was not leaking when I took it off the car. I have a bigger milodon oil pan now so it's up for grabs. I can take a few pics for you if you want.


It's got a 5.0/302 in it. I went ahead and got a new one online, delivered for 46 bucks, thanks for the reply!

  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  oil sender issue John J 6 331 07-20-2018, 02:57 PM
Last Post: John J
  Oil.... again Vinnie 31 2,163 07-20-2018, 02:53 PM
Last Post: Vinnie
  Oil change or not mpbsr 34 1,259 07-18-2018, 01:58 PM
Last Post: Fabrice
  Oil sender issue John J 0 146 07-16-2018, 10:28 PM
Last Post: John J
  oil cap gasket John J 9 392 06-05-2018, 11:56 PM
Last Post: secluff
  1972 351c oil pan repair BoweP 4 1,192 01-31-2018, 04:19 PM
Last Post: Ron Tanzi
  Hot weather Oil viscosity 73pony 2 593 06-10-2017, 09:28 AM
Last Post: Don C
  Oil - How many quarts with an aftermarket pan NewAgeMuscle 5 645 03-30-2017, 04:40 PM
Last Post: EBSTANG



Users browsing this thread: 1 Guest(s)