• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Door panel, lock knob
#1
I have to drill a hole in the new door panels for the lock rod to pass through. The question is exactly where to drill the hole. Does anyone have an original door panel that you could take some measurements from? Maybe from the back edge of the panel to the center of the hole and from chrome edge to the center of the hole (deluxe door panels). Obviously this is a one shoot deal so all help would be appreciated.

Thanks, Chuck
  Reply
#2
Hi Chuck,

Just went outside and measured it. On my deluxe door panels it's 90mm from the rear edge and 15mm from the chrome trim on the driver side. On the passenger side it's again 90 mm from the edge but only 12mm from the chrome trim, so I guess 100% accuracy is not needed.
Sorry for the metric measurements but that's all I have here at the moment.

[Image: 1z21rv4.png]

Mike

"If I were you...... I´d rather be me."  Tongue

Check out my video:
http://www.7173mustangs.com/thread-my-mustang-in-action

  Reply
#3
Here is a really neat, free program that sits on your desktop..it converts just about anything.
http://joshmadison.com/convert-for-windows/
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  door guts Copestang 1 177 07-24-2018, 06:35 AM
Last Post: mustang7173
  Dash end panel oddity Pegleg 2 206 07-03-2018, 10:55 AM
Last Post: donkost
  Door Jamb Vent Covers ITMike5.0 7 395 05-03-2018, 04:09 PM
Last Post: Mikes73
  Hood lock install Jeff73Mach1 37 8,226 04-25-2018, 03:22 PM
Last Post: Jeff73Mach1
  73 door window noise after rebuild samckay 0 171 04-22-2018, 12:29 PM
Last Post: samckay
  Deluxe Door Woodgrain Insert andy72 29 1,383 04-21-2018, 06:39 PM
Last Post: andy72
  Best deluxe Replacement Door Panels Stanglover 29 1,624 03-07-2018, 08:47 AM
Last Post: Stanglover
  Trap door question Danno 0 277 03-06-2018, 06:48 PM
Last Post: Danno



Users browsing this thread: 1 Guest(s)