• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Turnkey not working
#1
HI Guys

I did the duraspark ignition switch
and i have a High Torque Starter in my 460cid engine.

It should be all right connected.

In my interrior there is everything unplugged.

My Headlights are working correctly and also my windshield wipers too.


My turnsignal is not working. Bulbs are ok.

I earth the engine correctly and also the battery.

When i bypass the + post to the starter post with a cable the starter turns well.

I also dont know if my ignition system is working.

Are there any cables in the interrior wich need to be connected to let the starter work?

Another strange thing is.
The Headlight and wiper always works when i install the battery.
I mean i dont have to turn the key on run or something i can everytime put the lights on and off... Is that correct?

Now my question.
Wich calbes are neccessary for the starter?
I know the 2 cables wich needed to connect on the solenoid but wich else are there? From where does the starter gets his "run" ?

Also could that be that the solenoid is not working?
It looks very old and bad. I bought i new one and hope it comes soon.

What do u think?

Thanks
Andreas
  Reply
#2
Edit:

Turnkey is working.
My wiper dont work when i turn my key in off position.

I srsly hope that the solenoid is defect.
Are there any other reasons why it dont work?
Are there any fuse for the engine bay?
And wich cable is gives the start function for the starter?
My cables looks clean at all

Regards
Andreas
  Reply
#3
Your headlights work weather the key is in the ignition or not. They are however the only thing that should work without a key in the ignition. Sounds like you crossed up some wires installing the Duraspark. Stop and put everthing back the wa it was.

[Image: 2rr7aiv.png]

Just cruising along minding our own business when BAM!!! The LAWS show up.
  Reply
#4
Did you just hook up the high torque starter?You may have a wire crossed there?If so,there are videos on you tube showing wiring up a hi-torq starter .

[Image: 1_11_01_14_4_00_47.jpeg]
460 , Edelbrock Performer carb. + intake , 204 / 214 cam , Pertronix Flamethrower 2 billet dizzy + coil , Crites long tubes , C6 .









  Reply
#5
Definitely sounds like you flipped some wires around.

As far as the turn signals not working, that might be a bad flasher if you had that issue separately. To replace it you'll have to pull off the dash pad and look for it above the glove box. They only cost $4 or $12 if you get a heavy duty one. Double check to make sure the ground wire is connected from the harness.

-KR

-Former 70 & 72 Mustang Owner.
-69 Torino GT, Formal Roof, 351W, Edelbrock 600 cfm, Edelbrock 351W Performer RPM intake, headers, AOD trans, dual flowmasters w/H pipe, Pertronix II Billet, 3.5 TRACLOC g/r, 15" Magnum 500s, 100A alt, aluminum radiator, electric fan, Pro-car seats, mini-starter...owned since Dec 13.
-70 Mach 1, 351W, Edelbrock E-Street EFI, VHX instrument cluster, Hooker headers, dual flowmasters, Pertronix II, 15" Magnum 500s, 150A alt, aluminum radiator, dual electric fans, Pro-car seats, mini-starter
  Reply
#6
headlight works always i think because i installed a relay for halogen headlights and there i have to go to the battery.
The wiper dont work if the key is off.

What did u mean "hook up the starter"?
I installed them with the two cables. the fat one to +pos on the solenoid and the smaller one to the starter post on the solenoid.

Ok the turn signal is because of the flasher5 thanks

But whats about my starter?

Are only these to cables neccesary to install it? Or wich cable is also needed? I mean there must be a run or start signal coming from the turnkey

Regards
Andreas
  Reply
#7
Wipers won't work with the key in the OFF position. The ignition must be in ACC or RUN to supply power to the wipers.

Let me check your shorts!
http://midlifeharness.com

[Image: Flamicon2.jpg]


[Image: oldfart.png]
  Reply
Share Thread:  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Power Window Not Working BeerDontCount 6 262 05-28-2018, 04:19 PM
Last Post: BeerDontCount
  Running lights/ dash lights not working RadRacer203 8 572 10-14-2017, 04:44 PM
Last Post: midlife
  turn signal indicators not working colonel 6 844 08-29-2017, 02:13 PM
Last Post: colonel
  Turn signals not working patrickob17 4 576 05-11-2017, 05:48 AM
Last Post: waterlife
  orig tach not working now ??? delawarebill 10 978 05-09-2017, 10:52 PM
Last Post: 72HCODE
bulb Power windows stopped working, Gauge cluster lights don't work Neubonik 3 530 12-16-2016, 12:05 PM
Last Post: Carolina_Mountain_Mustangs
  Console clock stop working Mark73mach1 2 781 05-07-2015, 08:57 PM
Last Post: Mark73mach1
  Dummy Lights Not Working 123FRANK321 2 544 02-08-2015, 03:33 AM
Last Post: 123FRANK321



Users browsing this thread: 1 Guest(s)