Not sure where to post this. Can someone show me a pic of washer nozzles ,
- Thread starter fordnutjm
- Start date
Help Support 7173Mustangs.com:
- Joined
- May 19, 2021
- Messages
- 1,390
- Reaction score
- 982
- Location
- Fort Mohave, AZ & So Cal (Upland)
- My Car
- 73 Grande will undergo three phase build process. Phase 1 is complete (driver). Phase 2 is interior/exterior restoration. Phase 3 is ++ performance.
Here’s the photo from the assembly manual.
Hope it helps.
Hope it helps.
- Joined
- May 31, 2023
- Messages
- 57
- Reaction score
- 18
- Location
- Sanford Florida
- My Car
- Factory big block car with automatic trans Air conditioner. It has had slight upgrades to eng,trans,rear end and braking . Back up camera in radio.
They mount to the bottom of the hood. They have a small hex to adjust them while the hood is closed. If you go to the 429 Mustang/cougar website there is a picture of a hood that’s opened . They have an index for where whatever you are looking for. The hose comes up through a hole in the bottom frame of the hood, then is routed to the left washer and goes across to the passenger side washer. The NPD kit is basically the hose only. Mine is a 71 ,but I imagine it is similar. The hose is routed /stapled to the main harness and starts up to the hood by the brake valve. The picture will help a bit,but requires a little ingenuity.
If I remember correctly, Scott Drake has a kit.
Your in luck, I am swapping hoods and haven't pulled the washer out yet. Here is some pictures.
fordnutjm
Active member
Thank you, that helps!
fordnutjm
Active member
Thank you, just what I needed!
fordnutjm
Active member
It does, thanks !
Daniel Carpenter part #2387
@ Kentucky Mustang
The only part not in the kit is the rubber grommet that feeds the hose thru the bottom of the hood. Be sure to save this and re use it.
Similar threads
