Search results

I'm looking forward to it!

I've had great success with Covercraft over the years. Outstanding quality

The actuators are functioning fine, but using the links provided, and a search of the forum, I could not find anyone with experience replating or refinishing them. Thanks!

I would have probably over looked that, Thanks!

Does anyone have experience replating the actuators? My originals operate but are definitely looking a little ratty!

I'll be there with my BOSS 1. I'm hoping it isn't 100 degrees like last year!

Does anyone have a source for theses valve cover wiring clips?

Center windshield support bracket?

Great video. Thanks!

Poorly written or software generated. I guess I never thought of the BOSS 351 as an "upscale luxury barge!"

Thanks. Yes, I am just looking for the plastic vent cap that is on top of the middle tube coming from the canister. I was hoping to not have to purchase a new canister to get one.

Wow, you certainly have a few! I have the canister, but am missing the vent cap. I'll keep an eye on your site for one for sale. Thanks.

The vent cap for the fuel vapor, or "charcoal" canister similar to the pic below.....

The plastic vent cap was cracked during restoration. I'm looking for a good used one from a 71-73 with no cracks. Thanks in advance!

The Chassis Assembly Manual indicates that there is a gasket between the master cylinder and the booster labeled C9AA-2B355-D for my 71 Mustang. However, I can find little if any information on this part, or its relative importance. Has anyone replaced this gasket with a master cylinder...

I realize the thread is a bit dated, but answering for those using the search function later. Yes, the Boss 351 uses those pieces.

Refinished my power steering bracket and hardware and replaced the power steering pump to power steering cooler hose. Next up, install my newly restored power steering pump!

Shop or Service Manual, Assembly Manuals and the MCA Judging Rules have been a great help to me. Also, there are a few online forums, including this one, that have been extremely helpful.

71 BOSS 351

I just dealt with the same issue on my 71. The grommet, to my knowledge, is not reproduced. If you search the forum for “washer hose routing” you will find some photos of the hoses as well as the grommet. I used those for comparison and found one similar on Amazon.